Welcome Guest! The IOSH forums are a free resource to both members and non-members. Login or register to use them

Postings made by forum users are personal opinions. IOSH is not responsible for the content or accuracy of any of the information contained in forum postings. Please carefully consider any advice you receive.

Notification

Icon
Error

HAV
Options
Go to last post Go to first unread
fluffyandy62  
#1 Posted : 29 July 2014 16:33:44(UTC)
Rank: New forum user
fluffyandy62

I am trying to explain HAV figures to operators at my place of work. We use hand-held polishing guns with a manufacturing rating of 6m/s2, does anyone have a simple way to explain this please?
Bigmac1  
#2 Posted : 29 July 2014 20:38:22(UTC)
Rank: Super forum user
Bigmac1

Turn it into a daily trigger time and give it in minutes, workers will understand the unit of time. Don't forget to double manufacturers magnitude or measure it accurately. Stick the trigger time on each piece of equipment and get operators to record times of usage on a former.
Salis  
#3 Posted : 30 July 2014 08:21:38(UTC)
Rank: Forum user
Salis

Don't rely on the manufacturers rating, this can change drastically depending on materials they are used on.

Get a simple Havs meter, example
http://www.arco.co.uk/products/55H9350 or you can hire one (SpeedyHire).

A lot of good stuff here: http://www.hse.gov.uk/vi...on/hav/vibrationcalc.htm

fluffyandy62  
#4 Posted : 30 July 2014 11:59:50(UTC)
Rank: New forum user
fluffyandy62

Thank you both I will look on the sites suggested. I have started using a point system that equates into time i.e. one point for 20 minutes on the gun. Using this method against targets and hours worked in the week I have worked out that last week’s actual average times on the guns was 12%.

Thanks again.
Canopener  
#5 Posted : 31 July 2014 12:25:02(UTC)
Rank: Super forum user
Canopener

I am not quite sure what you are actually trying to explain to them but I would have thought that something along the lines that vibration exposure is a combination of the LEVEL of vibration and the LENGTH of time exposed. The higher the vibration level and/or the longer the time exposed to that vibration, the greater the risk of suffering from vibration related conditions such as HAV etc etc.

However, using an acceleration figure isn’t always that meaningful to many, so you can use the HSE tools freely available on their website to convert this into exposure points and then calculate when the EAV/ELV would be reached. I use the tool to make a ‘ready reckoner’ for each tool.

Hope that makes sense/helps
imwaldra  
#6 Posted : 31 July 2014 16:54:58(UTC)
Rank: Super forum user
imwaldra

Note that HSE guidance now says that recording trigger times for everything is possibly over the top. Once you have the evidence about typical exposures, if they are miles away from the lower limits, then no need to worry much about 'routine' exposures, only those that unusually high.

Your low level monitoring via annual questionnaire, etc. would pick up any cases where exposures have risen.
Users browsing this topic
Guest
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.