Rank: New forum user 
|
Good evening, I was wondering if anybody could help me. After reviewing our site workplace transport risk assessment, its clear it needs to be more specific to areas instead of a whole site generic assessment.
I need to break down the areas individually, this will then allow me to look at the whole site, some areas are low risk i.e. 2 FLT in the warehouse, other areas are very busy I.e. 25 pickers & 30 FLT in an area. Could anybody guide me on the format they use. I was thinking of developing a spreadsheet with a number of drop downs i.e. number of staff in area/number of FLT in area/pedestrians in area/current controls, once this information is selected I wanted to risk rate, red/amber/green uisng a scoring system. Any suggestions or guidance would be much appreciated. Kind Regards,
Chris Pierce CMIOSH Health and Safety Manager
|
|
|
|
|
|
Rank: Super forum user
|
We could relate RAs to zones or modes of operation -FLT, pickers etc. it would be difficult to cover all the permutations of what and where the RAs apply on one document or it’s a large document. But that’s just a matter of endurance for you to build it up on a spreadsheet for you and the H&S team A one risk is missing one of the drop downs
The challenge is how to communicate that to the operators etc and I’m not sure if drop downs on a spreadsheet would achieve that, perhaps it comes back to a few pages about zones or modes of operation
With a bit more info about the setup and operation we can look at more options
|
|
|
|
|
|
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.