Rank: Super forum user
|
Does anyone know of a product that will clip to the top of a computer monitor that will block a light source from behind the monitor?
I have a situation where we can not move desks as they have to be customer facing, but there is a glass door in front of them. It already has a tinted film, but at certain times the sun (when low in sky) shines through the door into the eyes of the user (for up to 1 hour). As a result I have seen them fidgeting about and trying to duck below the screen, but this is not good. I obviously can not adjust the screen up as this brings its own problems. Something about say 6 inches (150mm), would probably do it. I did consider putting something on the door, but we want people to be able to see what is the other side.
So is anyone aware of such a product ?
Your hopefully
|
|
|
|
Rank: Super forum user
|
Hi Chris,
if you Google computer monitor hood there are a lot of products available. Although I have not used any of the recent flat screen monitor hoods, in the past I have used old CRT monitors with "hoods" and found them to be generally OK. Some typists that I worked with in the past insisted on monitor hoods irrespective of where their desks were located (their argument being that the hoods minimised distractions).
PH2
|
|
|
|
Rank: Super forum user
|
Thanks PH2
I tried to do an Internet search but all I got was screen filters. Didn't think to look for hoods, sadly I don't think the hoods I just looked up will do it.
the problem is the sun comes over the top of the monitor and as the monitor is set with the top at eye level, the user can see beyond the screen, directly at the sun. So I need something that goes upwards 150mm ish.
|
|
|
|
Rank: Super forum user
|
Surely a simple piece of cardboard could do this. One hour, at a particular time of the year.
|
|
|
|
Rank: Super forum user
|
Given the identified restrictions imposed on complying with the requirements of DSE in the original post; may I suggest that a light-filtering plastic laminate be applied to the glass - same stuff used to reduce heat and UV transfer?
Although this doesn't meet the requirement to prevent "framing" of the screen in a window, it will reduce the contract problem considerably.
The desks continue facing the customers, the view through the window remains "open", there are no obtrusive hoods or other "bolt-ons to peer around to enable face-to-face for user and client [assumption from post]; and there is minimal maintenance, cleaning etc.
Frank Hallett
|
|
|
|
Rank: Super forum user
|
Hi Chris,
Is there a way to usual any duplicate screen one to face the customer and second one as convenient to the user
I am sure some how its possible like in banks and all
regards,
Pradeesh
|
|
|
|
Rank: Super forum user
|
Chris, without getting 'eyes on' the situation it's difficult to know what the answer might be. I have never come across these screen hoods though (clearly a sheltered life here in Norfolk!).
1. If the door in question is an internal door, could you shade the windows 'further out'.
2. If not, could you experiment with venetian or vertical blinds to see if these sufficiently reduce the glare while allowing some degree of vision?
3. Alternatively, a 'full' blind and use a cheapo CCTV system?
|
|
|
|
Rank: Super forum user
|
Thanks for the input everyone.
Yes the door has this film on it, but when the sun is out in full force it seems not quite enough.
The door is external an opens both ways and we need to see if people are stood the other side, so I don't think blinds are an option. It is also a "high ish" traffic route. we do have cctv, but obviously only one way.
the user already has a double screen in order to do their work, so duplicating that again would not be good.
My only thought was a blue Peter solution as noted above, but was hoping that, there was some solution out there that might look a bit better.
The only other thought is if I can work out the exact part of the door a small poster may do the trick, and still allow general visibility.
It was a long shot, I think I was hoping some one had seen a shield or something elese, say a calendar that would run along the top of the screen (and upwards not over the screen itself - as I know it is Friday).
Seems I had better go and find some card and sticky back plastic (possibly poster paint). Just thought, if I make my own there could be a safety message on it.
Cheers all
Chris
|
|
|
|
Rank: Super forum user
|
Why not simply raise the screen that few inches for the short time that the sun is ever shining in this country, on the few days of the year that the sun sets in that position and the short time that the stray rays are a nuisance?
|
|
|
|
Rank: Super forum user
|
Thanks David
This person has already complained that their neck and shoulders hurt!. So I'm not sure I should suggest this, as we have been through the seat, screen, keyboard adjustment process with them (though their issue is poor posture).
|
|
|
|
Rank: Super forum user
|
|
|
|
|
Rank: Super forum user
|
Could be, It looks like those old plastic paper binder strips with a bit of double sided tape. And would require less blue peter skills. Could be a neat solution.
Thanks
|
|
|
|
Rank: Super forum user
|
One of my staff use one but they are out. I'll get the details on Monday and pass them on.
|
|
|
|
Rank: Super forum user
|
A Kurdziel
Thanks appreciate that and If they give any feedback to effectiveness if you are willing, would also be welcome.
Chris
|
|
|
|
Rank: Forum user
|
Red Dwarf fan to the rescue.
Mr Flibbles suggestion is neat, cheap, low tech and will probably look dead on.
I was going to suggest a car sun visor arrangement that the Op flips up from the back of the LED screen when they need it but Mr Flibble's ebay find looks better.
From my photography days, tinfoil is light proof and easy to get hold of.
You can laminate a piece between two bits of paper (just to make it presentable) and be assured that no light will get through.
Jeff
|
|
|
|
Rank: Super forum user
|
Thought for a moment you were going to suggest I get a mechanoid to stand between the door and computer screen. Better still sit at the desk and do the work.
I would probably find them with the silver foil wrapped around their heads to prevent harmful rays and mind control.
Interesting thought about car sun visor though if the plastic grippy thing and card (or silver foil laminated paper) does not work.
I would quite like it to look professional and not easily broken by passing idiots.
Chris
|
|
|
|
Rank: New forum user
|
|
|
|
|
Rank: Super forum user
|
Thanks RSOK
That does look interesting, may be worth a visit to a car accessory shop and study them to see if one can be easily attached to a monitor. The one in the advert looks about the right size.
|
|
|
|
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.