Hi we have a large metal heating oil storage tank (approximately 2000 Litres) next to our boiler room which is enclosed in a brick built building which is showing signs of corrosion and I am looking to have this replaced. Is anyone aware of what regulations would apply, so that I can research them before going out for tenders?

Ooops, too keen I mean to post this link; but an internet search will throw up other stuff too http://www.oilstoragereg...m8wsa2hMMCFUjJtAodqjsAAQ Stu

I think the oil storage regs only apply if you are storing oil outside. There is also PPG2 ( again this is really for outside). There is also a guidance doc "Get to know your oil tank" - OFTEC. Most of this is all about external storage, but may be worth a look. If you buy one of these plastic self bunded type tanks which is ok for external use, you will be covered. You may need planning permission, worth checking. Sorry I could not answer the actual question. Chris

Hi Glenn, no problem. As Chris has rightly said and as in the flow chart if the tank is wholly within a building then Oil Storage Regs wont apply but you will need to consider PPG2 and PPG26. But the guidance that is contained in the OSR can be shown to be as evidence of following the guidance even if there is no need to. Personally I would be seeking fire service advice or from a 'good' fire risk assessor if the tank is going to be next to the bolier house too. Don't forget if you are anywhere near a watercourse or aquifer then the EA will get twitchy noses too - especially if there is ever a leak and they are not aware of your operations etc. You can still get single skinned tanks, as well as the double ones; however the weak point is always the outlet and this should be protected from impact/tampering etc to ensure that you dont end up losing 2k litres of oil. HTH Stu