Welcome Guest! The IOSH forums are a free resource to both members and non-members. Login or register to use them

Postings made by forum users are personal opinions. IOSH is not responsible for the content or accuracy of any of the information contained in forum postings. Please carefully consider any advice you receive.

Notification

Icon
Error

Options
Go to last post Go to first unread
Admin  
#1 Posted : 20 February 2005 09:32:00(UTC)
Rank: Guest
Admin

Posted By Martin Taylor Hi everybody. we operate a hot melt glue process involving the application of glue to a plastic substrate by gun. Although the vast majority of cases are done safely we do occasionally get glue burns. Historically I have been concerned about providing gloves for operators being concerned that if glue were to get through the glove it would be held in contact with the skin for longer and worsen the burn. However as we do not seem to be able to eliminate this issue I am now minded to reconsider gloves. The other factor to consider is that the current job requires considerable dexterity - application of screws and components - so some of the obvious protective gloves are unsuitable. Do any of you have similar processes and have you identified suitable gloves to meet the combined requirements of glue protection and dexterity. thanks Martin
Admin  
#2 Posted : 20 February 2005 09:51:00(UTC)
Rank: Guest
Admin

Posted By Paul Leadbetter Martin Where dexterity is required, the gloves would normally be thin, tight-fitting plastic (vinyl, latex, nitrile, etc.) but these would offer little thermal protection. Greater thermal protection would be given by woven gloves of some sort (even when hot, the adhesive would probably be too viscous to pass through the weave) but at the cost of reduced dexterity. An ergonomic assessment of the operation might identify process changes to eliminate the risk of burns. Paul
Admin  
#3 Posted : 20 February 2005 10:55:00(UTC)
Rank: Guest
Admin

Posted By Martin Taylor thanks for the thoughts Paul - I am minded that the close knit type opf gloves probably will give some protection - am planning some trials - but would find it very useful if somebody already does it and can vouch that there is no increased risk of burn from increased contact time. As you say the rubber type gloves are simply not suitable for dexterity thanks again Martin
Admin  
#4 Posted : 21 February 2005 09:51:00(UTC)
Rank: Guest
Admin

Posted By Neil Pearson I suspect there won't be a neat answer in terms of PPE. The glue will present health hazards as well as injury hazards in its uncured state, so you should look at process/equipment changes that reduce the physical exposure of operators.
Users browsing this topic
Guest
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.