Rank: Guest 
|
Posted By Sandra Lord
We employ forklift engineers and occationally they have to work at height to gain access to the top of rams, mast etc. Can anyone advise on a good, safe method of obtaining the required access without risking a fall from height. A ladder is not a viable option as there isn't a safe flat surface on which to rest it. They usually stand on the top of the overhead guard, which is covered with a board to prevent feet etc going through the guard. The normal height of the guard is around 2 metres. There is nowhere that a harness could safely be attached. has anyone been in this situation? regards, Sandra
|
|
|
|
|
|
Rank: Guest
|
Posted By Andrew Joule Land
If this is a regular occurance contact the Manufacturer in case they have any specialist access equipment. - see February SHP page 84 item 59 - they may be able to help.
AJL.
|
|
|
|
|
|
Rank: Guest
|
Posted By Shaun Brennan
Sandra
you could try using a bandstand, which is a small ladder with a working platform on it, it has guardrails on it and edge protection and it is on wheels so you can push it around the forklift mast and position it where you need it.
if you require anymore advice have a look on one of the tool hire websites like speedy or GAP
Kind Regards
Bugsy
|
|
|
|
|
|
Rank: Guest
|
Posted By Sandra Lord
Thanks for the info. Bugsy, do these bandstands collapse down to fit into a small van? It would be useful if we could find out where to buy them so that all the vans are equiped with one just in case it is needed on the job. If you know where they can be purchased as aposed to hired, please let me know. I'll check out the mag for the info, thanks, Sandra
|
|
|
|
|
|
Rank: Guest
|
Posted By Richard Hinckley
Sandra
Not sure if of interest to you but we have developed with many of the leading UK FLT Suppliers a procedure for safely accessing their trucks which is supported by a bespoke training programme.
Please email me richard@totalaccess.co.uk if of interest...
|
|
|
|
|
|
Rank: Guest
|
Posted By Robert K Lewis
Sandra
The below link is typical of what the major manufacturers such as SGB, HAKI and NSG are producing. Many fit it estate cars and small vans.
Even if you had a harness fixing point it would be superfluous as an operative will hit the ground before full deployment. I personally think this is a practice that has become so long standing that it is now almost unquestioned until you asked the question. I think that some good WAH training is required as well to break some of the habits.
www.uktower.com
Bob
|
|
|
|
|
|
Rank: Guest
|
Posted By Ali
There are numerous proprietary working platforms, podium steps etc that can be used. Standing on top of an overhead guard is not only risky, but may contravene the Regs as there may be no fall prevention in place as the actual height is no longer an issue.
|
|
|
|
|
|
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.