Rank: Guest
|
Posted By MICHAEL T We have had an accident where one of our staff has slipped as he got into the back of the van. He is saying that because he is a bit on the small size that he had problems getting in and out. We have a 'vehicle usage risk assessment' but this has never been considered a hazard for a person of 'normal' height. Also, he never reported the accident until we found about it from our wages department 15 days later so its impossible to discover if this accident WAS caused at work. As he had time off, it also meant that my F2508 went in late. Advice required. Regards Mike
|
|
|
|
Rank: Guest
|
Posted By Luke. Hi Michael,
Unfortunately, whether the IPs accident happened at work or not is irrelevant once the IP CLAIMS the injury happened at work. Once he has done that, the onus is then on the company to report to HSE (if it falls into RIDDOR guidelines).
It seems like a fairly open and shut one, just speak to him, get his involvement.. ask him (in a nice way) if this has been a problem, why has he not brought this to your attention - get his involvement. Also ask him what he would class as suitable access & egress for a man of his build...
|
|
|
|
Rank: Guest
|
Posted By MICHAEL T There was no question about the RIDDOR, we took this as a works accident and reported it as soon as we found out.
|
|
|
|
Rank: Guest
|
Posted By John J Michael,
I'd be looking at beefing your accident reporting procedure up. I expect accidents reported the same day or, if something has appeared over night, the next day either in person or phoning in. This includes accidents that happen at weekend. There is no excuse for late reporting, if you don't know about it you can't stop it happening to someone else,
John
|
|
|
|
Rank: Guest
|
Posted By A Campbell Michael,
i agree with both posts, in addition to reviewing your risk assessment and maybe a safety brief or toolbox talk being issued to remind employees that they should take care when entering/exiting the rear of the vans?
|
|
|
|
Rank: Guest
|
Posted By Ron Hunter People falling in and out of vans - a not uncommon lost-time injury scenario. If this is frequent activity then R/A should be looking beyond the factory-fitted slippy steel plate either side of the tow-bar and considering the reasonably practical approach of fitting proper permanent or fold-down steps, along with a consideration of the volume and height of the cargo space.
|
|
|
|
Rank: Guest
|
Posted By Bob Youel An area that is not always adequately considered in RA and work thereafter is the make up of the individual people undertaking the work e.g. very tall / very short - very strong / very weak etc; this subject is considered in the 'POP' areas of MHSW & I would advise all to consider such things at all stages
|
|
|
|
Rank: Guest
|
Posted By steve e ashton Agree with Bob...
Every risk assessment is completed with certain basic assumptions underlying the conclusions.
Unless those assumptions are spelled out clearly and explicitly, it is inevitaable that sooner or later one of the assumptions will prove to be unfounded, and misfortune will follow.
So - the 'loading and unloading of vehicles' RA might specify underlying assumptions to include: Dry conditions, not excessively windy (?windspeed limits specified?) Personnel undertaking duties trained, reasonably alert, reasonably fit, normal height, wearing loose clothing, etc etc etc..
Alternatively, and equally validly (and requiring much less bureaucracy to fill out in the assessments) the operator training might include a review of the assessment with every employee doing the job, with a specific request for them to identify any areas of concern - both on starting the job and periodically afterwards. Thus tall people might complain of banging their heads on the frame or the door catch, visually impaired may complain at lack of contrast on edge markings -and the vertically challenged may ask for stairs with smaller risers.
In other words, any risk assessment (and the management control measures resulting) must be appropriate for the people doing the job. It's no use claiming 'we've done the assessment so we are covered' if the assessment does not take account of individual differences...
There's legislation to require such specific considerations for young persons and for expectant mothers - but it must be seen as normal "good practice" for other differences as well.
Steve
|
|
|
|
Rank: Guest
|
Posted By Raymond Rapp Surely the size (height), weight and general dexterity of people cannot be adequately addressed via a risk assessment or even anticipated. It is a fact of life that people vary in shape and size. It sounds like a tall story to me, no pun intended.
Seriously, manual handling is a prime example where generic issues are looked at and there is neither the time or requirement to do individual assessments.
Ray
|
|
|
|
Rank: Guest
|
Posted By Bob Youel I investigated a case where the IP was so small she had to get inside a chest freezer to clean it - changes to an upright sorted the problem -& turned out to be better all round!
|
|
|
|
Rank: Guest
|
Posted By kgalbraith Michael
Can I ask which door he was entering / exiting. I've had a problem before with access / egress to vans where there is no step at the side of the van. I have encouraged access from the step at the rear only using the side door for loading / unloading materials received or laid out by an op in the vehicle.
K
|
|
|
|
Rank: Guest
|
Posted By D. Hilton Raymond
It can if you base it on the 95th percentile of the ethnic model applicable to the individuals concerned
|
|
|
|
Rank: Guest
|
Posted By Raymond Rapp Thank Mr Hilton for reminding me of that fact...very useful. :)
|
|
|
|
Rank: Super forum user
|
Sorry yto resurrect this, but I saw this: http://www.shponline.co....know&article_id=9515 and I thought of you... The '95th percentile' is not going to include many of the less able in our society... RA should be appropriate to the people carrying out the task - not just the middle range fit healthy, middle sized, middle visioned, middle hearinged etc etc etc... Steve
|
|
|
|
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.