Posted By Graham Sargeant I would be interested in views anyone may have re: the anchoring of fall arrest harnesses worn by scaffolders during erection/dismantling of the scaffold. The SG4 guidance issued by the National Access and Scaffold Confederation, is as far as I am aware an approved safe system of work by the HSE, and states clearly that scaffold standards should not be used as anchor points for harnesses, but I have come across safety clamps (essentially a scaffold coupler which is bolted on, and provides an eye to hook your harness), which are designed to be used specifically on the standard of the scaffold. I have spoken to the clamp manufactures who say thier product is tested and safe to use, and am awaiting written proof, and I have written to the people who produce the SG4 notes, who say they are aware of the existance of clamps but have not recieved suitable data to encourage the use, but is being considered for later versions of the guidance SG4. So I am left a little confused, any views or comments would be appreciated. Should I use these clamps or ignore until 100% approved??? Thanks

Posted By Graham Sargeant Thanks for your reply, I have today recieved in the post details from the clamps manufactures of the tests made, and it shows to my mind beyond doubt the clamp itself is well constructed and will withstand being used in a fall arrest situation, one of the tests was made dropping 100kg attached to a clamp anchored 2mtr from a coupling point on the scaffold tube, interestingly enough the clamp withstood the test, but the scaffold tube had a 6 degree bend after testing. I don't think there is any problem with quality of the clamp, but my point of worry still remains the practice of clamping to scaffold standards. Any views or comments???

Posted By Graham Sargeant I confirmed with NASC that anchoring a harness at foot level, although they agree is not the best method, is aceptable if you are unable to anchor at a higher point (again they reinforced the use of a standard as an anchor is not suitable). The demonstration material I recieved with the clamps in question show them being used specifically at a height of about 2mtr from the board level (ie: just about head height). As I pointed out, I am convinced the clamp will withstand the use as a fall arrest device, but if used in this manner I feel it could have an adverse effect on the scaffold structure itself, what do you think? Look forward to your views.